This is where you can decide, in detail, how you want ME Consultant to be set up when it starts.
How many decimal places to display?
Do you want tooltips turned on by default? They're great for learning the program, but you might want them turned off later.
What are your rapid clearances? There are safety and efficiency considerations.
You can opt for a full-blown inch or metric setup, or a combination.
How many decimal places to display?
Do you want tooltips turned on by default? They're great for learning the program, but you might want them turned off later.
What are your rapid clearances? There are safety and efficiency considerations.
You can opt for a full-blown inch or metric setup, or a combination.
Close Tolerance Software
Tools for Metalworking Professionals
Created by
Michael Rainey
